82% polyester, 18% spandex fabric weight: 6.61 oz/yd (224 g/m) upf 38-40 double layer front bias binding in black or white sewn with an overlock stitch smooth and comfortable microfiber yarn four-way stretch material stretches and recovers on the cross and lengthwise grainsplease note that contact with rough surfaces and velcro fasteners should be avoided since they can pull out the white fibers in the fabric, damaging the swimsuit's appearance. Frequently asked questionssizing detailswe understand that sizing runs differently with each company and because this is an online shop there is no way for you to see the items in person or try them on so we have made sure that size charts with detailed measurements are included in the picture section of every listing with both imperial and metric measurements. For our cut and sew garments detailed diagrams explaining the measurements are also included. Please refer to these charts in order to get the best fit.If you find that you are between sizes please order a size up. Since we cannot see each other in person it is up to you to choose the best fit for your size. Once you place the order, the item is then custom created especially for you and production starts very quickly. We have a very thorough inspection process to make sure that your item comes out looking just right and free of defects. Please note: colors may vary due to the settings on your device or computer monitor and due to the printing process.
Printing processmany of our garments are produced using an all over sublimation printing process where we start with a ready made white garment as a base that is then laid flat, the print is applied to the front, the garment is flipped over and then the print is applied to the back. Because of this process there may be areas around the seams, under the arms, near the shoulders and sometimes near the collar where the print doesn't fully take because these areas aren't able to lay completely flat during the printing process. This is completely normal and is not considered a defect. This does not occur with our cut and sew garments because the print is applied to the fabric and then the garment is cut & sewn by hand.Dyedall of our garments use white fabric as a base and then the print is applied on top of the fabric using a sublimation process. This is very different from a dye process where fabric is dyed a certain color and the dye goes into the fabric and because of this sometimes you may find that, especially with dark colors such as our printed black garments, they may not be as dark or rich as the black dyed clothing you have at home. There is no other way to achieve the type of prints we offer because if we started with a black fabric base the print would not show up on top.
Also colors may appear lighter when the garments are stretched. These are not considered defects.
Colors may also vary due to the settings on your device or computer monitor. Care instructionsmachine wash cold, inside-out, gentle cycle with mild detergent and similar colors as the polyester fabric may make colors run. Tumble dry low, or hang-dry for longest life. High temperatures during washing and drying may shrink the fabric. Cool iron inside-out if necessary.
Please note that contact with rough surfaces and velcro fasteners should be avoided since they can pull out the white fibers in the fabric, damaging the garments' appearance. Please note: we cannot be held responsible for damage to the garments due to failure to follow these care instructions. The production company makes this decision based on several factors to try to get your order completed as efficiently as possible and delivered to you as quickly as possible.